Download Datasheets TC4404 Device 
Download datasheets and other technical documentation for microcontrollers

Chip-Review.com - download datasheets and technical documentation for microcontrollers


PICmicro Microcontrollers
PICmicro flexible microcontroller solutions provide results!

Analog & Interface Products
A broad spectrum of analog products with a focus on power management, thermal management, linear and mixed-signal solutions

KEELOQ Authentication Products
KEELOQ is a patented code-hopping technology

Memory Products
A broadest selections of memory devices on the market for embedded control applications

microID RFID Products
Radio Frequency Identification Tags (RFID)
rfPIC Microcontrollers
New UHF radio frequency 8-bit microcontrollers
There is also live chat that is always available - http://newmobilebonuses.com.

Home - Analog & Interface Products - Power Management - Power MOSFET Drivers - TC4404 Device, download datasheet

Download Datasheets TC4404 Device


The TC4404 and TC4405 are CMOS buffer-drivers constructed with complementary MOS outputs, where the drains of the totem-pole output have been left separated so that individual connections can be made to the pull-up and pull-down sections of the output. This allows the insertion of drain-current-limiting resistors in the pull-up and/or pull-down sections, allowing the user to define the rates of rise and fall for a capacitive load; or a reduced output swing, if driving a resistive load, or to limit base current, when driving a bipolar transistor. Minimum rise and fall times, with no resistors, will be less than 30nsec for a 1000pF load. There is no upper limit. For driving MOSFETs in motor-control applications, where slow-ON/fast-OFF operation is desired, these devices are superior to the previously-used technique of adding a diode-resistor combination between the driver output and the MOSFET, because they allow accurate control of turn-ON, while maintaining fast turn-OFF and maximum noise immunity for an OFF device. When used to drive bipolar transistors, these drivers maintain the high speeds common to other Microchip drivers. They allow insertion of a base current-limiting resistor, while providing a separate half-output for fast turn-OFF. By proper positioning of the resistor, either npn or pnp transistors can be driven. For driving many loads in low-power regimes, these drivers, because they eliminate shoot-through currents in the output stage, require significantly less power at higher frequencies, and can be helpful in meeting low-power budgets. Because neither drain in an output is dependent on the other, these devices can also be used as open-drain buffer/drivers where both drains are available in one device, thus minimizing chip count. Unused open drains should be returned to the supply rail that their device sources are connected to (pull-downs to ground, pull-ups to VDD), to prevent static damage. In addition, in situations where timing resistors or other means of limiting crossover currents are used, like drains may be paralleled for greater current carrying capacity. These devices are built to operate in the most demanding electrical environments. They will not latch up under any conditions within their power and voltage ratings; they are not subject to damage when up to 5V of noise spiking of either polarity occurs on their ground pin; and they can accept, without damage or logic upset, up to 1/2 amp of reverse current (of either polarity) being forced back into their outputs. All terminals are fully protected against up to 2 kV of electrostatic discharge.

Datasheet and Other Documentation

Detailed Content

Lit. Number

Download

 

TC4404/05 Datasheet

21418a

Download TC4404/05 Datasheet

Status

In Production

Specification Chart

Configuration

Peak Output Current (A)

Output Resistance (Ohms)

Maximum Supply Voltage (V)

Input/Output Delay (tD1, tD2) (ns)

Dual, Inverting

1.5

10/10

18

15/32

Additional Features

Independently-Programmable Rise and Fall Times
Low Output Impedance: 7 ? Typ
High Speed tR, tF: <30nsec with 1000pF Load
Short Delay Times: < 30nsec
Wide Operating Range: 4.5V to 18V
Latch-Up Protected: Will Withstand > 500mA
Reverse Current (Either Polarity)
Input Withstands Negative Swings Up to 5V

Package Options

8 PDIP(P), 8 SOIC(S)



Chip-Review.com, 2008-2015
Chip-Review.com - download datasheets
There is also live chat that is always available - http://newmobilebonuses.com.